| Michael Wilson | Friday, September 13, 2013 - 07:01 am 
I am trying to figure out what flat number is sufficient with out going over board. I need to stick to a number with out losing profits to the cost of materials, I am thinking if 185 quality would be alright? I know the fact above 200 quality can kill the corporations. I was told or some where the quality 180 is fine. I think I need to search around. I want to stick with a flat number.
Could someone please lighten me up a bit, so I could stick to a number. My theory is this, if the Raw Materials Used by the month goes beyond 1,000M in the cost, lower the quality down and wait till its below 1,000M in cost to save the corporation or something like that or 120 quality as standard plus 80 quality equals over 200% in sales which should go over 250% in sales with total of 180 quality + upgrades, so 120 + 80 = 200% or I meant like 120 + 60 = 180 = what in sales or try 200 in quality, but I am sure above quality 200 will kill the income, but I am trying though.
Because when I lowered the quality, I had some good gains in turn overs and that is how I knew any where above 200 quality would kill it in the cost of Materials and income turn overs.
Please help.
Thank you Simcountry. |
| Michael Wilson | Friday, September 13, 2013 - 01:15 pm
Well, I am thinking to start from quality 200 as it is. I am sure the fact 100% certain, way above 200 quality kills it. Its been a while now, so, when I did adjust it, the income when up after I lowered the quality down, so it did work. Im going to leave it at quality 200 and go from there and if it works well, then 200 it is. I do not believe having quality 213-215 to make full 274% works that quite well. Hopefully 260-270% should work well. |
